Domat Control System › Forums › Hardware (english) › FC010 mode of "Master – Slave"
This topic contains 0 replies, has 1 voice, and was last updated by Václav Turek 19.9. 2012 11:40.
Using of mode “Master – Slave” of FC010 you must use folowings bus-terminals for creating bus with FC010 in mode “Master” FC010 in mode “Slave” and room controller UC010.
Use terminals K2+ and K2- for connect bus on controller in mode “Master”
Use terminals K1+ and K1- for connect bus on controller in mode “Slave” (K2+ and K2- stays empty
You must be logged in to reply to this topic.
We would like to inform you about the release of the new version of Merbon SCADA 1.5.3 software on our website. This release includes modifications to both the service itself and the Merbon SCADA installer.
The main focus is on air conditioning and consumption measurement, familiarization with our product news and an invitation to trainings that await us by the end of this year.
This year on Amper exhibition was full of our HW and SW news. Read our quick report!
The training is designed for PLC and SCADA programmers, but also for others interested in integrated systems with Modbus RTU and TCP protocol.
This training is focused on new development tool Merbon IDE.
This training is used for basic introduction to the system. We will guide you through the installation of software and show how to work with Merbon SCADA.