HT200 – Touch screen operator unit

Update from version 2.3.0.3 and newer:

File downloadHT200 –Touch screen operator unit version 2.4.0.11 (HT200.sh)

 

Firmware upgrade instruction:

Please, do not switch off power supply during firmware upgrade.

It is possible to upload new version of HT200 application from web browser on the device IP address (the browser PC must be in the same network). To access the service web, enter the password. In section Device management -> New application and web on device choose file „HT200.sh“ (file name must be „HT200.sh“). HT200 will be restarted automatically.

Update from versions older than 2.3.0.3:

File downloadHT200 –Touch screen operator unit version 2.4.0.11 (HT200.sh)

 

File downloadWeb Upgrade (web_2.0.1_Upgrade.tar.gz)

 

Firmware upgrade instruction:

Please, do not switch off power supply during firmware upgrade.

It is possible to upload new version of HT200 application from web browser on the device IP address (the browser PC must be in the same network). To access the service web, enter the password. In section Device management -> New application and web on device choose file „WEB_Upgrade.tar.gz“. HT200 needs to be restarted after this upgrade and the browser needs to be closed and opened again as well. Upgraded web can be found on the IP address of the HT200. This web can be used only to upload „HT200.sh“ file. Device will restart itself after this upgrade. The webpage should be refreshed automatically.

 

PDF    Release Notes