“Cannot open project” message

Domat Control System Forums SoftPLC IDE (english) “Cannot open project” message

This topic contains 0 replies, has 1 voice, and was last updated by  Jan Vidim 27.2. 2009 12:12.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #12509

    Jan Vidim
    Keymaster

    This may appear if a project which has been created or edited in a newer version is attempted to open in an older version which does not contain all libraries (drivers) used in the project.

    Cure: Use the same IDE version which worked last time or use the most recent version.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.